03-10-2014, 08:32 PM
Joruss, you're right. With 1:1, signal to noise ratio will be small, as only fraction of pot range will be used. That's not neccessarely bad, beacause it's still better than non linear response. Maybe some linear combination of both, will suit the best.
To summarize, make athleast 2 holes for mounting point on each pedal rod. One at 1:1 and the other at 1:2. That way you can play with it and maybe even drill third one somewhere in between. For gas pedal, I'd definately go with 1:1, but for cluch and brake something in between could do the job. Trial and error is allways the best experimental method
To summarize, make athleast 2 holes for mounting point on each pedal rod. One at 1:1 and the other at 1:2. That way you can play with it and maybe even drill third one somewhere in between. For gas pedal, I'd definately go with 1:1, but for cluch and brake something in between could do the job. Trial and error is allways the best experimental method
AA™| rane